One Way to Make Your Own Besom Using Branches and Sticks

I suggest gathering these under a full or waxing Moon phase as they will hold more helpful energy. Your Besom can also be used to sweep out the negativity in your sacred place and/or wherever you are going to cast a circle. Remember to ask the tree you get your branch and sticks from even if they are laying on the ground no longer attached to the tree. It is always better to take what you need from a tree or shrub off of the ground beneath it rather than cutting pieces off the tree or shrub. Get a branch about 3 to 4 inches little taller then you are. Gather good size bunch of unstift smaller branches, I have found getting the sticks from under a shrub or pine tree make the best sweeping part of the Besom, if possible the size difference in them should be no more the approximately 2 inches in size. After gathering the branch and sticks remember to thank the tree for the parts it has given you and to leave an offering such as some water out of a container you have drank from. You need a ball of natural thin twine or some type of undryed vine. Tie the twine or vine to the branch making sure it is tight and will not slip off (you may want to by an angular cut about 4 to 5 inch up from the bottom of the branch to slip this twine or vine when securing it. (The size you have at the bottom of your Besom made from the twigs is up to you. Usually doing 2 to 4 layers of sticks make a good size Besom. Lay your first stick against the branch pull the twine or vine around the stick as tightly as you can, continue doing this until you have made you first layer of sticks pull the twine or vine in the opposite direction the you have been placing the in a tightly as possible and tie it off but do not cut the twine or vine. For the next layer you will follow the same instruction except lay the sticks in the opposite direction from the first layer. The third layer will go in the same direction as the first layer and the fourth layer goes in the same direction as the second layer. To help ensure you sticks stay secure to the branch at the end of each layer of sticks pour white glue over the sticks and twine or vine and make sure it gets down to the branch. If you want you can even put glue on the branch as you lay each first layer stick. Let each layer of sticks dry for approximately 24 hours before adding the next layer. When you have done the last layer and have used glue to help hold it together let the entire Besom dry a minimum of 72 hours before using it.